Laying tiles on walls and floors

Laying the tile is preceded by a series of preparatory processes. The initial stage is the purchase of the necessary materials. Next, you need to prepare the surface, leveling the walls with plaster and then polishing. Upon completion of the work, it is necessary to prime the completely flat surface.
Then the adhesive solution is prepared, during the preparation of which the proportions of water and glue must be correctly observed. The mixture is prepared using a technical mixer and with the gradual addition of dry glue. If you prepare too liquid glue, it will float down the wall, and it will be impossible to distribute too thick consistency uniformly on the wall.
Laying tiles begins from the bottom up. The first row of tiles is laid out above the floor with the use of a wooden strip, the horizontal of which is leveled by the level. In order for each subsequent row to go out horizontally, it is necessary to nail the vertical strips into the corners, having previously leveled them with a plumb line.Next, nails are hammered into the slats, and between them a strong kapron thread is pulled. With the help of this thread the horizontal display of the next rows is controlled.

Stages of wall tiling


Glue is applied to the tile using a notched trowel. Then the tile with glue is gently pressed to the wall, observing the gap thickness of 2-4 mm. The use of dividing crosses simplifies the control over the gaps, the task of which during thermal expansion is to prevent the tile from peeling off. To tiled masonry turned out to be perfectly smooth, you must use a level in the work.
For tile trimming you will need a tile cutter. Not an experienced person to work with tile cutter will be quite difficult. Therefore, to simplify the task, you can use the grinder or pliers. It is recommended to hide a tile with a cut edge under furniture or fittings.

Ceramic tile flooring


It is recommended to start laying tiles on the floor from the far corner towards the door by marking the floor with a thread. Flatness is controlled by level. After the completion of the laying work, it is necessary to clean the surface of the tile from particles of glue and do the grouting. A rubber spatula is required for this case.When choosing a grout it is better not to save on the material, because the quality of the grouting material will determine the appearance of the installation as a whole. Its color does not need to be tied to the tone of the tile, but this is already a matter of taste.

Related news

Laying tiles on walls and floors image, picture Laying tiles on walls and floors Laying tiles on walls and floors Laying tiles on walls and floors Laying tiles on walls and floors Laying tiles on walls and floors Laying tiles on walls and floors Laying tiles on walls and floors Laying tiles on walls and floors Laying tiles on walls and floors Laying tiles on walls and floors Laying tiles on walls and floors Laying tiles on walls and floors Laying tiles on walls and floors Laying tiles on walls and floors Laying tiles on walls and floors Laying tiles on walls and floors Laying tiles on walls and floors Laying tiles on walls and floors Laying tiles on walls and floors Laying tiles on walls and floors Laying tiles on walls and floors Laying tiles on walls and floors Laying tiles on walls and floors Laying tiles on walls and floors Laying tiles on walls and floors Laying tiles on walls and floors Laying tiles on walls and floors